個人積分：43分
文章編號：8924853
個人積分：42分
文章編號：8926044
個人積分：6分
文章編號：8927100
個人積分：40分
文章編號：8929803
個人積分：0分
文章編號：9097911
個人積分：178分
文章編號：9099585
tomfly wrote:
能不能請教一下，您剪的這段文字，有提到DOT標籤一定要用噴漆烤漆在哪裡?
在下英文不太好，找不到相關說明...
謝謝指導先...(恕刪)
小弟幫您貼一下關於標籤的部分敘述是在這段
S5.6 Labeling.
S5.6.1 Each helmet shall be labeled permanently and legibly, in a manner such that the label(s) can be read easily without removing padding or any other permanent part, with the following:
Manufacturer's name or identification.
Precise model designation.
Size.
Month and year of manufacture. This may be spelled out (for example, June 1988), or expressed in numerals (for example, 6/88).
The symbol DOT, constituting the manufacturer's certification that the helmet conforms to the applicable Federal motor vehicle safety standards. This symbol shall appear on the outer surface, in a color that contrasts with the background, in letters at least 3/8 inch (1 cm) high, centered laterally with the horizontal centerline of the symbol located a minimum of 1 1/8 inches (2.9 cm) and a maximum of 1 3/8 inches (3.5 cm) from the bottom edge of the posterior portion of the helmet.
Instructions to the purchaser as follows:
(1) 'Shell and liner constructed of (identify type(s) of materials).
(2) 'Helmet can be seriously damaged by some common substances without damage being visible to the user. Apply only the following: (Recommended cleaning agents, paints, adhesives, etc., as appropriate).
(3) 'Make no modifications. Fasten helmet securely. If helmet experiences a severe blow, return it to the manufacturer for inspection, or destory it and replace it.'
(4) Any additional relevant safety information should be applied at the time of purchase by means of an attached tag, brochure, or other suitable means.
個人積分：0分
文章編號：9100075
個人積分：79分
文章編號：9114235
