jlkalft wrote:
不是C1000啦~是...(恕刪)
Use this information to
determine whether external factors cause the problem and how to remedy the
situation.
1. The fault indicator will illuminate indicating the UPS detected a problem.
2. An alarm will sound, alerting that the UPS requires attention.
3. One or more additional load/battery level LED indicators will be illuminated
to provide a diagnostic aid to the operator, as described below:
All. On bypass due to output overload (beep every half second)
A. On bypass due to over temperature condition (beep every 4 seconds)
B. On bypass due to DC bus overvoltage (beep every 4 seconds)
C. On bypass due to control power supply failure (beep every 4 seconds)
D. On bypass due to PFC failure (beep every 4 seconds)
E. On bypass due to inverter failure (beep every 4 seconds)
A&C. UPS failed battery test (long beep every minute)
C&E. UPS shutdown due to command from communication port (SNMP); no
beep
會叫多半是有問題，你的情況有點符合A&C. UPS failed battery test (long beep every minute)
如果是每分一長音大概就電池故障了
或者是Low battery Two short beeps every five seconds; less than two minutes of run time remaining
其餘請自己看情形對照看可能是那種，又或者你沒打開。
